Mitsubishi Electric MELDAS 600M Series Instruction Manual page 24

(Note 1)
(Note 2)
(Note 3)
(Note 4)
(2) Operations in the data setting area
The key is input at the position where the cursor is displayed. If a cursor is not displayed, the key
input is invalid.
When a key is input, the data appears at the cursor position, and the cursor moves one character
space to the right.
(Note) The overwrite mode is entered when the
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1. Operating the Setting and Display Unit
5) key input
INPUT
Press the INPUT key.
The contents in the data setting area are only displayed until the
These contents are invalidated if the screen is changed. The data is written into the
memory when the
Special settings may be required depending on the data type. Refer to each item.
The cursor may move to the right of the display item depending on the data type.
If an illegal key is set, an error occurs when
/ keys: Moves the cursor one character to the left or right.
→ ←
1)
The cursor is at the position
shown on the right.
2)
Press the → key.
INSERT key: Enters the insert mode.
1)
Move the cursor to the position
where the data is to be inserted.
2)
Press the INSERT key, and
then the data keys.
INSERT 7 7
the screen is changed.
search engine
The contents in the data setting area are fixed, the data
setting is processed, and the results appear on the
screen.
The cursor moves to the next position.
Tool offset amnt
Ofset No Length
11 -12345.678 -12345.678
12 -12345.678 -12345.678
13 -12345.678 -12345.678 -12345.678 -12345.678
14 -12345.678 -12345.678 -12345.678 -12345.678
15 -12345.678 -12345.678 -12345.678 -12345.678
16 -12345.678 -12345.678 -12345.678 -12345.678
17 -12345.678 -12345.678 -12345.678 -12345.678
key is pressed.
INPUT
1 2 3 7 7 7 4 5 6
The cursor moves one character space to the right.
1 2 3 7 7 7 4 5 6
The cursor moves in the data setting area.
1 2 3 4 5 6 4
The data is inserted, and the cursor moves to the right.
1 2 3 7 7 7 4 5 6
7
DELETE
I – 9
L wear Radius
12.205 -12345.678
-12345.678 -12345.678
INPUT
is pressed. Reset the correct data.
INPUT
4
5
4
, keys are pressed, or when
C•B ESC
R wear
key is pressed.