Mitsubishi Electric MELDAS 600M Series Instruction Manual page 91

2.6.2 Checking the program
Press the menu key
Press the menu key
The tracing starts immediately when the check mode is selected.
(1) Menus used for program checking
Program
Program
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Check search
Check continu
Menu
This changes the screen to the Check Search screen.
Check
The program to be checked is searched for on this
search
screen.
This checks the program continuously.
Check
continu
This check the program per block.
Check
step
This cancels the program check.
Check
reset
This erases the graphics displayed on the screen.
Erase
Each time this menu is pressed, the graphics are
erased in the order of rapid traverse and cutting feed.
This displays the machining program being drawn on
display
the screen.
This changes the display scale and the display
position.
Display
range
(Note) When the display range is changed, the
displayed graphics are erased.
This changes the plane and system to be displayed.
The axes corresponding to X, Y and Z are set in the
operation parameters.
• Parameter (370020 to 370025)
$1
X X1
Display
mode
Y Y1
Z Z1
(Note) When the display range is changed, the
displayed graphics are erased.
This changes the direction of the view when displaying
in the three-dimensional display mode.
Rotate the cube at the lower right by inputting the
Rotate
, , →
↑ ↓
key.
The graphics displayed on the screen are erased.
This is used when tracing.
trace
search engine
2. Monitor (Operation) Screens
to select the program to be checked.
or to select the check mode.
Check step
Details
$2
X2 ...... Axis of each system
corresponding to X.
Y2 ....... Axis of each system
corresponding to Y.
Z2 ....... Axis of each system
corresponding to Z.
and ← keys, and fix with the
I – 76
Type Reference
(2) Check Search
C
screen
(3) Checking
B
continuously
(4) Checking one
B
block at a time
(5) Canceling the
C
program check
C
C
2.6.3 Changing
the display range
A
2.6.4 Changing
the display mode
C
2.6.5 Changing
the display angle
A
INPUT
2.6.1 Tracing and
C displaying the
machine position
−
−