Mitsubishi Electric MELDAS 600M Series Instruction Manual page 129

3.1.2 Erasing the tool offset data
(1) Erasing one line of tool offset data at the cursor position
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Move the cursor to the line to
be erased.
(Note) One of the following methods can be used to designate the line.
• Using the cursor movement keys
selected.
• Press the menu key
key.
INPUT
2)
Select erase.
Menu
Line clear
3)
Press the or
Y INPUT
To cancel the erasing, press a
key other than or
Y
search engine
3. Setup Screens
The cursor appears at the data item of the selected
offset No.
Ofset No
101
102
130.023
103
104
105
106
107
and
↑
, set the offset No. in the setting area, and press the
Offset No.
The menu is highlighted.
A message confirming the erasing appears.
INPUT
The selected line of data (one line amount) is cleared to
key.
zero.
Without the cursor moving, that line becomes the first
line of the display area.
.
INPUT
Ofset No
102
103 130.023
104
105
106
107
108 -12345.000
I – 114
Length L wear Radius R wear
0.000 0.000 0.000
23.630 10.000 42.140
10.000 23.340
0.000 0.000 0.000
0.000 0.000 0.000
0.000 0.000 0.000
0.000 0.000 0.000
, move the cursor to the line to be
↓
Length L wear Radius R wear
0.000 0.000
0.000
10.000 23.340
0.000 0.000
0.000
0.000 0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
-123.000 -12345.000 -123.000
0.000
8.000
3.000
0.000
0.000
0.000
0.000
0.000
3.000
0.000
0.000
0.000
0.000