Mitsubishi Electric MELDAS 600M Series Instruction Manual page 459

2.12 Diagnosis-related operation messages
Select a menu
Device is illegal
Modal output not
possible
Modal clear not possible • The modal cancel process failed.
One-shot output not
possible
Continue display not
possible
Can't write data
Change Ope. test mode
2.13 Waveform-related operation messages
Scroll execution
Refresh execution
Executing sampling
Input the axis name
Input axis name/signal
No./bit
Input file/sub-ID/item/
data
Change the area
Sampling conditions are
illegal
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message
• A device No. was set without selecting a menu operation.
→ Press any operation menu and input the device No. with a menu
highlighted.
• The designated device is illegal.
• The modal output process failed.
• The one-shot output process failed.
• Continuous display is not possible, because data is not set at the cursor
position.
• The data cannot be written.
• Operation of the Operation test screen was attempted when the
operation adjustment mode was not selected.
Message
• The waveform display is being scrolled.
• The waveform is being redisplayed.
• The waveform data is being sampled.
• This appears when the data type is selected in the Ch1 or Ch2 data
setting area.
→ Input the name of the axis to be sampled.
→ Set the sampling conditions common for Ch1 and Ch2.
• This appears when an NC file is selected in the Ch1 or Ch2 data setting
area.
→ Change the area with the Area change menu, and set the
required data.
• The data cannot be sampled as the setting conditions are illegal.
→ Review the data, vertical scale, sampling rate and horizontal scale
on the Condition setting screen.
search engine
CHAPTER 4 APPENDICES
IV – 17
Details
Details