Mitsubishi Electric MELDAS 600M Series Instruction Manual page 330

(Continued from the previous page)
Operation mode
Parameter set
Scale
Rotation status
2. Explanation area
(2) Menus
OpeTest
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display item
This displays the currently selected operation
mode.
This displays the number of the currently
selected operation parameter group.
This displays the feed amount scale.
(Feed amount) = 0.001 degree × (Scale)
This displays the state of the auxiliary axis.
This displays the initialization procedures for
the auxiliary axis absolute position detection.
Menu
This designates the number of the auxiliary axis for which initialization
or test operation is to be carried out.
Axis
After pressing this menu, set the auxiliary axis number 1 to 6, and
select
then press the
in the selected area. The default value is 1.
This changes the designated axis to the operation adjustment mode.
Absolute position initialization and test operation are not possible in
modes other than the operation adjustment mode.
mode
If the operation adjustment mode valid signal is not ON, or if the
auxiliary axis is being executed, the operation adjustment mode
cannot be entered.
This changes the absolute position initialization mode for the
designated axis.
Abs
pos set
The absolute position can be set by starting in this state.
This menu can be selected only in the operation adjustment mode.
When the display item "Form abs posn set" is set to origin point
Origin
method, press this key at the position to be used as the origin point.
pos set
The absolute position will then be set at this position.
search engine
6. Maintenance Screens
Details
Details
key. The information on that axis will appear
INPUT
I – 315
Display details and range
0: Handle
1: Manual
2: JOG
3: Incremental
0: Operation parameter
group 1
1: Operation parameter
group 2
2: Operation parameter
group 3
3: Operation parameter
group 4
0: 1-fold
1: 10-fold
2: 100-fold
3: 1000-fold
Normal rot / Reverse rot /
Stop
Type
A
C
C
C