Mitsubishi Electric MELDAS 600M Series Instruction Manual page 125

Tool offset type II
The shape offset amount and wear offset amount are set separately. The shape offset amount is
furthermore divided into length and radius dimensions.
Of the offset data, the length dimension data is used for the tool length and tool position offset, and
the radius dimension data is used for the tool radius and three-dimensional tool radius offset.
1. Program No.
3. Display
area
!
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Caution
To set the tool compensation amount (tool length and tool radius) during automatic operation, set
it during single block stop.
Use the following to set the compensation amount during automatic operation.
State during
automatic operation
During single stop
Other than the above
search engine
3. Setup Screens
To set the tool length compensation
amount
Whether the compensation amount is to
be validated from the next block or from
the next H No. command can be selected
with the parameter (110051 Op Tolcomp
ofs valid).
The compensation amount after setting is validated from the tool
compensation command block that is several blocks ahead of the
block being executed.
I – 110
2. Absolute/Incremental
selection
To set the tool radius
compensation amount
The compensation
amount is validated from
the next block.