Mitsubishi Electric MELDAS 600M Series Instruction Manual page 348

When machine motion is stopped by using the FEED HOLD switch, automatic operation will be
restarted by turning ON the CYCLE START switch.
Memory operation terminates when M02 or M30 in the program is executed. The M02 or M30 lamp
on the machine operator panel is turned ON.
To forcibly terminate automatic operation, turn ON the RESET switch.
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
CAUTION
Carry out dry operation before actually machining, and confirm the machining program, tool
offset and workpiece coordinate system offset.
search engine
4. Operation Mode
II – 15