Mitsubishi Electric MELDAS 600M Series Instruction Manual page 475

No.
AX0104 Some ax does
AX0105 Invalid return
AX0106 Rotate work
Downloaded from ManualsNet.com
Appendix 3. Alarm Messages
Message
An axis exists that did not cross
not cross Z the detector Z phase in the initial
phase reference point return after the
power was turned ON.
During the manual reference point
return, the direction of the return
differed from the axis movement
direction selected with the axis
selection key.
The rotation axis workpiece
compen position compensation amount
excessive exceeded 3mm.
search engine
CHAPTER 4 APPENDICES
Details
IV – 33
Remedy
• Move the machine by an amount
equivalent to one or more rotations
of the detector in the opposite
direction of the reference point and
carry out the reference point return
again.
• The +/− direction selection with the
axis compensation key is incorrect.
The error is canceled by carrying
out the feed in the correct direction.
• Turn the rotation axis workpiece
position compensation OFF.
• Set the deviation of the workpiece
center position and table rotation
center to 3mm or less.
• Check whether the workpiece
coordinate zero point is at the
center of the workpiece.