Table of Contents
Advertisement
1.5.7 Changing the menu
The menu can be used to select screens and to select functions or setting items. Up to ten menus can be
displayed at once.
To select the menu, use the menu key below the menu display.
To change the menu, use the menu changeover key.
(Refer to the following figures.)
(Menu change)
Menu
display
Downloaded from
ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1. Operating the Setting and Display Unit
key : The operation menu is canceled.
The screen selection menu for the currently displayed screen group appears.
The display for the currently displayed menu is highlighted.
key : When there are more than 11 menus, this key displays the remaining menus.
This key can be used when " " or " " is displayed at the upper right of the menu.
Alarm/warning
RDY:MEM :ALM
Operate
Trace
Erase
search
ON
Menu keys
RDY:MEM:ALM
Area
Program
change
tree
RDY:MEM:ALM
Next
axis
RDY:MEM:ALM
Area
Program
change
tree
search engine
PROGRAM CHECK COMPLETE
Program
Display
Display
Rotate
display
range
mode
Posn
Program
Run-out
Common
display
modal
time
variabl
Menu keys
When menu changeover key is pressed
on Position display3 screen
When menu changeover key is pressed again
Program
Run-out
Posn
Common
modal
time
display
variabl
Menu keys
I – 26
This indicates that there are more
than 11 menus, and that there are
menus following the currently
displayed menu.
Program
This indicates that there are more
Check
than 11 menus, and that there are
menus before the currently
displayed menu.
Menu
changeover key
Local
variabl
Local
variabl
Menu
changeover key
Menu
changeover key
Advertisement
Table of Contents
