Mitsubishi Electric MELDAS 600M Series Instruction Manual page 488

Error No.
PR0601
PR0602
PR0603
PR0604
PR0605
PR0606
PR0607
PR0608
PR0611
PR0612
PR0615
PR0621
PR0622
PR0623
PR0624
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 3. Alarm Messages
Message
A skip command (G31) was
No skip
issued even though there are no
such command specifications.
The multi-step skip command
No multi skip
(G31.n) was issued even though
there are no multi-step skip
specifications.
Skip speed 0 The skip speed is 0.
No axis or more than 2 axes was
G37 illegal axis
designated in the automatic tool
length measurement block.
The H code is in the same block
H and G37
as the automatic tool length
commands in same
measurement command.
block
The H code was not yet
H command not
designated in automatic tool
found before G37
length measurement.
Before the area commanded by
Signal turned illegally
the D command or the parameter
with G37
deceleration area D, the
measure-ment position arrival
signal went ON, or resulted in not
going ON.
A skip command was issued
Skip during radius
during the radius compensation
compen
processing.
A high-accuracy mode (G61.1)
No hi-preci (G61.1)
command was issued even
spec.
though there are no such
command specifications.
A high-accuracy (die)
No hi-preci die
(G61.2/G61.3) command was
(G61.2/3) spec.
issued even though there are no
such command specifications.
A high-accuracy (part) (G61.5)
No hi-preci part
command was issued even
(G61.5) spec.
though there are no such
command specifications.
The knot was not correctly
NURBS knot error
designated in the NURBS
command.
NURBS weight error The weight was not correctly
designated in the NURBS
command.
NURBS degree error The number of stages was not
correctly designated in the
NURBS command.
The control point was not correctly
NURBS control point
designated in the NURBS
error
command.
search engine
Details
• Check the specifications.
• Check the specifications.
• Designate the skip speed.
• Designate only one axis.
• Designate the H code before the
automatic tool length
measurement command block.
• Designate the H code before the
automatic tool length
measurement command block.
• Reconsider the program.
• Designate a radius
compensation cancel command
(G40), or remove the skip
command.
• Check the specifications.
• Remove the high-accuracy
mode command from the
program.
• Check the specifications.
• Remove the high-accuracy (die)
command from the program.
• Check the specifications.
• Remove the high-accuracy
(part) command from the
program.
• Designate the knot following the
NURBS command format.
• Designate the weight following
the NURBS command format.
• Designate the number of stages
following the NURBS command
format.
• Designate the control point
following the NURBS command
format.
IV – 46
Remedy