Mitsubishi Electric MELDAS 600M Series Instruction Manual page 196

Display item
Life
Used
L wear
R wear
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
This sets the life corresponding to each tool following one of the
following methods: usage time (mins.), number of mounting
times (number of times installed on the spindle) or number of
uses (number of holes drilled).
The method to be used is decided by the data format designated
in "Mthd".
The life is infinite when "0" is set.
(Note) Number of uses count
The number of uses is counted when the command
changes from rapid traverse command (G00, etc.) to
a cutting feed command (G01, G02, G03, etc.).
Note that, rapid traverse or cutting feed commands
with no movement are invalid.
G00
+1 count
This displays the usage data of each tool following the method
designated by the tool life management method.
(Note) This data is not counted during machine lock,
auxiliary function lock, dry run or for a single block.
Not used.
Not used.
search engine
3. Setup Screens
Details
G01 G00 G04 G01 G04 G01
In cutting
In cutting feed
feed
+1 count
I – 181
Setting range
Usage time:
0 to 4000(min)
Number of
mounting times:
0 to 9999
(times)
Number of
uses:
0 to 9999
(times)
Wear
(Not used)
G00
Usage time:
0 to 4000(min)
Number of
mounting times:
0 to 9999
(times)
Number of
uses:
0 to 9999
(times)
Wear
(Not used)
0
0