Mitsubishi Electric MELDAS 600M Series Instruction Manual page 368

(c) When the manual/automatic simultaneous valid axis is moving, the G92 command from the
(d) When several axes are interpolated and moving with automatic operation, all axes will stop if
(e) The interlock will not be applied even if the "manual/automatic simultaneous valid" signal is
(f) If the "manual/automatic simultaneous valid signal" is turned ON for an axis moving with the
(g) If the "manual/automatic simultaneous valid signal" is turned ON for an axis during reference
(4) Other precautions
(a) If only the automatic operation mode is selected and the manual operation mode is not
(b) Even if one automatic operation mode and one manual operation mode are selected, all
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
6. Operation Switch Functions and Other Functions
Program operation mode (Y708)
(memory mode)
Automatic operation start (Y710)
Automatic operation block progress
Jog mode (Y700)
Manual/automatic simultaneous
valid Z axis (Y522)
Feed axis selection + Z axis (Y4E2)
Axis moving signal + Z axis (X3A2)
automatic operation will be executed after the axes, including this axis, have stopped.
the "manual/automatic simultaneous valid" signal turns ON for even one axis. When moving
the axes independently such as during automatic reference point return, or during rapid
traverse when the control parameter "G0 interpolation OFF" is ON, only the axis for which the
"manual/automatic simultaneous valid" signal is ON will stop.
turned ON for the virtual axis in virtual axis interpolation.
automatic operation's G90 modal or G53 command and the manual/automatic simultaneous
valid axis is moved manually, when the "manual/automatic simultaneous valid" signal turns
OFF, the end point of automatic operation will be deviated by the amount the axis was moved
manually.
During the G90 modal, the command path will be returned to during the next block.
point return and the axis is manually moved, the reference point return operation will be
executed again.
When the reference point is reached manually, the interlock will be released, and the block
will end.
Manual operation after the block is completed will follow the manual operation block.
selected, the "manual/automatic simultaneous valid" signal will be invalid.
manual operations of an axis for which the "manual/automatic simultaneous valid" signal is
OFF will be invalid. Note that if the automatic operation handle interrupt option is added,
interrupt can be applied with handle feed.
search engine
"OPW0105 Internal interlock axis exists"
G91 G01 X100. Z100. F1000 ;
Movement
Movement with
with jog feed
automatic operation
II – 35
Movement with
automatic operation