Executing Restart Search - Mitsubishi Electric MELDAS 600M Series Instruction Manual

2.5.3 Executing restart search

Restart search is used to designate the position to restart the program.
The search completion position (position on the local coordinate system) is the setting value of the O, N,
B and P items when the
completed.
The modal information of the S, M, T and B (latest 16 Ms) in the program are sequentially updated and
displayed so that the program up to the restart position is executed.
Each modal information at the completion of the search is used at the next automatic start as the current
modal values.
(1) Operation method
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Restart search
1)
Set the program device and
directory for restart search.
The setting method is the
same as that for an operation
search. Refer to section "2.4.1
Executing an operation
search".
2)
Set the program No., and
press the key.
INPUT
Set the sequence No. block No. and
No. of block executions in the same
manner in N, B and P respectively.
(Note 1) Steps 1) and 2) are the same as for operation search and top search. Refer to "2.4.1
Executing an operation search".
(Note 2) Always set the program No.
(Note 3) P sets the number of times that the block targeted for the search (or machining time
calculation) appears.
For example, if a block in a subprogram is searched, and the subprogram is called
out several times, the block to be searched is also executed several times. Thus,
which execution block to search must be set. (If "0" is set, it is handled in the same
manner as "1".)
To search the block that appears first, or to search for a block executed only once,
this item does not need to be set.
search engine
menu key is pressed. "Restart Pos" appears on the screen when
The selected device name and directory path appear in
the setting column.
Dev ice HD
Directory /PROGRAM
The set numbers appear in the setting column.
I – 56