About The Built-In Cd-Rw Drive; Using The Cd-Rw Drive - Yamaha AW2400 Owner's Manual

About the built-in CD-RW drive • Using the CD-RW drive
1
A built-in CD-RW drive is a device that lets you create or
play audio CDs, backup and restore data from the internal
hard disk, and read data from a CD-ROM.
IMPORTANT
• Even if a CD-RW drive is operating normally, it may fail a read
or write operation approximately once in five hundred times.
• Yamaha will take no responsibility for any damages, direct or
consequential, that may result from the use of the above CD-
RW drive.
To insert a disc into the CD-RW drive, press the eject
switch. The disc tray will open. Place the disc on the tray,
and gently push the disc tray in.
NOTE
• The disc tray is ejected electrically. If the disc tray is not ejected
when you press the eject switch, turn on the power of the AW2400
and press the eject switch once again.
12
AW2400 Owner's Manual

About the built-in CD-RW drive

Using the CD-RW drive

Eject hole Eject switch
■ Handling
1 Never touch the objective lens.
B Be careful that the objective lens does not become
dusty or dirty.
C If the objective lens becomes dusty, use a commer-
cially available blower etc. to blow the dust off with
clean air.
D Since the inside of the drive contains powerful mag-
netic circuitry, do not allow any magnetic material to
come near the drive. (In particular, any metallic frag-
ments, screws, or pins that enter the drive mechanism
will cause operation to fail.)
■ Removing a CD in an emergency
If you are unable to remove the disc by pressing the eject
switch, insert a wire of less than 2 mm diameter (such as a
straightened paper clip) into the eject hole, and push gen-
tly. However, pressing the eject switch will not eject the
disc when the AW2400 is in the following states, so do not
use this method in such cases.
• When the AW2400's power is "OFF"
• When the disc is being accessed (data is being read,
written, or erased)
• While in CD PLAY mode
CAUTION
• This removal method is for use in emergencies such as when
you cannot remove the disc due to a malfunction of the disc
tray or a power failure. Do not use this method unnecessarily,
since doing so will damage the CD-RW drive.