Changing The Display Of A Working Curve Graph; Menus; Termination Of Measurement - Hitachi ZA3000 Series Instruction Manual

3.13 Changing the Display of a Working Curve Graph

3.13 Changing the Display of a Working Curve Graph
3.13.1

Menus

3.14 Termination of Measurement

The scale can be changed individually for each working curve
graph. Move the cursor over the working curve graph and right-
click to display a popup menu. Click the desired item in the
menu.
The function of each item is described below.
Refer to 3.10 "Changing the Display of a Monitor Graph" and
3.12 "Changing the Display of a Profile Graph."
 Trace:
 Ruled Line
 Change Scale:
 Auto Scale:
 Vertical Axis Auto Scale:
 Reset Scale:
 Print Graph:
 Copy Graph:
When all of the set unknown sample measurements are finished,
the display changes to the Data Process window and the results
of measurements are displayed. If autosave is enabled for
analysis results, the file will be saved to the specified folder at
this time. If you don't want to carry out other measurement in
succession or retry the same measurement, stop the cooling
water and go to "4. CHECKING THE RESULT."
For continuing measurement, refer to "7. TERMINATING OR
CONTINUING MEASUREMENT."
When exiting the software, the following dialog box will appear.
Confirm the dialog box and then exit the software.
3 - 72
Refer to 3.10.1 "Trace."
Refer to 3.10.2 "Ruled Line."
Refer to 3.10.3
"Signal/Change Scale."
Refer to 3.12.2 "Auto Scale."
Refer to 3.10.4 "Y-axis Auto-
Scale."
Refer to 3.10.5 "Reset Scale."
Refer to 3.10.6 "Print Graph."
Refer to 3.10.7 "Copy Graph."