Hitachi ZA3000 Series Instruction Manual page 241

3.1.6 Setting
Standards Table
NOTE: This function gives the "P" mark if data are obtained
that indicate the possibility of bumping. It does not
indicate the occurrence of bumping of the sample.
 Setting of temperature program for cleaning the cuvette
This is a function to reduce the memory effect of the
previous measurement on the next measurement by
heating the cuvette. Two methods are available for
heating the cuvette: heating the cuvette to the maximum
temperature and heating it according to the temperature
program. For details, refer to 5.6 "Cleaning Cuvette" in
Chapter 5.
(1) Click the [Standards Table] button (<5> in Fig. 3-1) to
display the Standards Table window.
Fig. 3-10 Standards Table Window
3 - 17
3.1.6
<1>