Measurement With Conditions Input; Generation Of Measurement Conditions - Hitachi ZA3000 Series Instruction Manual

3. MEASUREMENT WITH CONDITIONS INPUT

3.1 Generation of Measurement Conditions

The input of measurement conditions and measurement
procedure are described here using as an example analysis by
the working curve method with the autosampler.
The procedure for creating new measurement conditions is
described next. This procedure should be observed in the
following cases.
 When changing the measurement conditions used at auto-
start
 When changing the measurement conditions read out from
the existing file
Reference: 2.3.4 Opening a Files
For creating measurement conditions, open the Method window
(Fig. 3-1), then open the windows in succession by clicking the
buttons on the toolbar from left to right, and enter your settings.
For changing over the windows for entry, either click the
respective buttons or use the Previous
toward the right end of the toolbar. To cancel an item that has
been set or changed on an opened window, click the cancel
button on the toolbar.
<13>
Enlarge the icon in the tool bar
<1> <2> <3> <4>
Fig. 3-1 Method Window
3 - 1
and Next
<12>
<11>
<5> <6> <7> <8> <9>
3.1
buttons
<14>
<10>