Figure 6-21 Configure Slave Modem; Figure 6-22 Slave Status After Changing Mode - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual
v. Select Add SLAVE. (See Figure 6-20)
Add a Slave by matching the Unit ID and CDU IP Address you recorded earlier for each
Slave (See Figure 6-21). All Slave statuses will remain red until the modems are
changed from Maintenance Mode to NCW mode. (See Figure 6-22)
w. Change Mode to NCW. (See Section 6.4.2)
x. Enter in the MSK and Pass Phrase. (See Section 7.2)

Figure 6-21 Configure Slave Modem

Figure 6-22 Slave Status after Changing Mode

6-18
1000-7075 Rev D