Ncw Rx Comm Tab; Figure 8-11 Ncw Rx Comm Tab; Table 8-7 Ncw Rx Comm Tab - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual

8.7.7 NCW RX Comm Tab

This page provides receive DCOM statistics for the network Terminals. Note that a
Terminal does not receive its own DCOM bursts, so the Terminal making this report will
not appear in the list of Sources.
Refer to Table 8-7 NCW RX Comm Tab for data descriptions for this window.
Control/Indicator/Function
Source Name
C/No (dB-Hz)
Info Rate (Kbps)
Modulation
Code Rate
Spread Factor
Hub Assist
Peak Alloc Rate (kbps)
Avg Alloc Rate

Figure 8-11 NCW RX Comm Tab

Table 8-7 NCW RX Comm Tab

Name of the Terminal transmitting these bursts.
This records the highest received C/No since the last Reset from the
named source.
This records the highest burst information rate received from the named
source since the last Reset.
This records the modulation type of the burst recorded above.
This records the code rate of the burst recorded above.
This records the spread factor of the burst recorded above.
This records if the burst recorded above was hub assisted.
This records the peak allocated user rate (kbps) for DCOM bursts
assigned to be received from the named source since the last Reset. Note
that the peak allocated user rate can be higher than the peak information
burst rate if the Terminal is using multiple demodulators.
This records the average allocated user rate (in Kbits/sec) received from
the named source since the last Reset. This is a filtered average using the
following formula; Ave Alloc Rate = previous Ave Alloc Rate × N/(N+1) +
new value × 1/(N+1) (where N is 10).
8-23
Description
1000-7075 Rev E