Ncw Setup Tabs; Ncw Parameters Tab; Figure 8-15 Ncw Setup Parameters Tab - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual 1000-7075 Rev E
8.8

NCW Setup Tabs

The tabs displayed in the Network Centric Waveform Setup screen allow you to view
settings. Generally, these fields are set to defaults and should not be changed unless
directed by the Network Administrator. To view this page (Configure → Network
Centric Waveform Setup → Parameters).

8.8.1 NCW Parameters Tab

This page contains information required by the NCW scheduler to compute burst rate
and power. The Secure Voice Channel information is only available when the selected
mode is Network Centric Waveform with SOW. Use the Advanced tab to set parameters
on how the scheduler reacts to changes in the network-operating environment.
Changes take effect after clicking on the Apply button.
Refer to Table 8-11 NCW Setup Parameters Tab for data descriptions for this window.

Figure 8-15 NCW Setup Parameters Tab

8-28