Ncw Tx Comm Tab; Figure 8-12 Ncw Tx Comm Tab; Table 8-8 Ncw Tx Comm Tab - L3 Communications MPM-1000A Operator's Manual

Ruggedized ip modem

Table of Contents

MPM-1000A Operator Manual

8.7.8 NCW TX Comm Tab

This page provides transmit communications statistics for the network Terminals. Note

that Terminals do not transmit to themselves, but do transmit to the Broadcast address.

Refer to Table 8-8 NCW TX Comm Tab for data descriptions for this window.

Control/Indicator/Function

Destination Name

EIRP (dBW)

Info Rate (kbps)

Modulation

Code Rate

Spread Factor

Hub Assist

Peak Alloc Rate (kbps)

Ave Alloc Rate (kbps)

Name of the Terminal receiving these bursts.

This records the highest EIRP used to transmit a burst to the named

destination since the last Reset.

This records the highest burst information rate transmitted to the named

destination since the last Reset.

This records the modulation type of the burst recorded above.

This records the code rate of the burst recorded above.

This records the spread factor of the burst recorded above.

This records whether the burst recorded above was hub assisted.

This records the peak allocated user rate (kbps) for DCOM bursts

assigned to be transmitted to the named destination since the last Reset.

Note that the peak allocated user rate can be higher than the peak

information burst rate if the Terminal is using multiple modulators.

This records the average allocated user rate (kbps) transmitted to the

named destination since the last Reset. This is a filtered average using

the following formula; Ave Alloc Rate = previous Ave Alloc Rate ×

N/(N+1) + new value × 1/(N+1) (where N is 10).

8-25

Description

1000-7075 Rev E

Table of Contents