Snmp Dialog; Figure 5-3 Snmp Mode Change; Figure 5-4 Snmp Configuration Dialog - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual 1000-7075 Rev E
5.2

SNMP Dialog

Figure 5-3 SNMP Mode Change shows the first screen to appear after selecting SNMP
Configuration (Configure  SNMP). Selecting No on this screen allows you to change
SNMP parameters relevant to the current mode as shown in Figure 5-4 SNMP
Configuration Dialog with the current mode set to V2.
In SNMPV2 operation, you may change the community string to match that of the
Modem. In SNMPV3 operation, you may change the type of Authentication and enter
the credentials required to communicate at the level required. Selecting Yes on this
screen will say that the HCI must be restarted to change SNMP Mode settings and that
you want to restart now.

Figure 5-3 SNMP Mode Change

Figure 5-4 SNMP Configuration Dialog

5-2