Table 8-11 Ncw Setup Parameters Tab - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual
Control/Indicator/Function
Modem
Node Name
Transmit Chain Gain Factor
Receiver Sensitivity (G/T)
Max Terminal EIRP
Min Terminal EIRP
Contact EIRP
Data IP Address
RFOW Spread Factor
RFOW B/W Segment
Contour Offsets
EIRP Contour Offset
G/T Contour Offset
SFD Contour Offset
Secure Voice Channel (Only visible when SVOW is active)
Downlink Frequency (not
shown)
Uplink Frequency (not shown)
Transmit Power (not shown)
Enable (not shown)
Terminal Type
Network Controller Capable
Net Member Only

Table 8-11 NCW Setup Parameters Tab

Node name for this Satellite Terminal in the network. The name must be
unique and consist of less than 13 alphanumeric characters.
Transmit gain of the Terminal from the Modem‟s TX IF output through the
antenna.
Terminal Antenna Gain versus System Noise Temperature.
Maximum EIRP from the antenna.
Minimal EIRP from the antenna.
Initial EIRP used when entering the network:
For a net controller this is the initial power used for the Reference FOW
burst.
For a net member this is the initial power to use on a contention login
(CROW) Orderwire burst.
IP Address of the Modem data port (J1).
DSSS spread factor to be used for the Reference FOW.
Select the BW Segment ID number corresponds to the downlink RFOW
BW Segment.
Offset to the terminal EIRP due to uplink beam contour.
Offset to the terminal G/T due to downlink beam contour.
Offset to the terminal SFD due to beam contour.
RF Receive Frequency in kHz and Modem IF Frequency in Hz. (Display
only).
RF Transmit Frequency in kHz and Modem IF Frequency in Hz. (Display
only).
Modem IF transmit power level in dBm.
Selects whether or not the SVOW function is enabled.
Select if the Terminal can operate as a Network Controller.
Select if the Terminal will operate only as a Network Member.
8-29
Description
1000-7075 Rev E