Table 8-3 Ncw Statistics Tab - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual
Control/Indicator/Function
Reference FOW
Assigned ROW
Data COMM
Byte/Packet Counts
Reset Time
Statistics Time
Polling
Elapsed Time (seconds)
Number of nodes in network
Reset
Statistics
Right clicking on one of the status boxes will bring up a Thresholds dialog.
Use this dialog to change the default thresholds and changing the colors
of the status boxes between green, yellow and red based on the error
percentage.

Table 8-3 NCW Statistics Tab

The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
These statistics also indicate the measured signal to noise ratio (SNR) of
the RFOW bursts.
The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
NM-only Terminals are not required to receive AROW bursts, so this field
is blanked for NM-only Terminals.
The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
Displays total bytes/packets of IP traffic for both transmitted and received
user data traffic.
Time that statistics were last reset. Reset button to reset all statistics.
Time that statistics were last requested.
Automatic polling parameters. The minimum interval is 1 second.
Displays the total time between the last statistics reset and the last
statistics update.
Count of active network nodes. (seconds)
Button to reset the statistics and counts to zero.
Button to request currents statistics (if polling not enabled).
Hint
8-16
Description
1000-7075 Rev E