Figure 9-3 Ncw Network Tab; Table 9-1 Ncw Network Tab - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual
Control/Indicator/Function
Node Name
Status
Role
Terminal Type
Connect Button
Disconnect Button
Terminate Button
Network Terminal List
Data IP Address
Satellite Information
Satellite
Terminal Home Beam
Apply button

Figure 9-3 NCW Network Tab

Table 9-1 NCW Network Tab

Displays the Node name assigned to the Terminal. Node name can be
changed from the NCW Setup page.
Displays the connect status of the Terminal.
Indicates the current Terminal role (NM or NC).
Indicates that the Terminal can be a net controller or a net member only.
Terminal Type can be changed from the Configure → Network Centric
Waveform Setup → Parameters.
Click the Connect Button to join or establish a network.
Click the Disconnect Button to log out of a connected network. Valid if the
Terminal is connected as a network member. The Terminal will continue
to track the network time-base and NC signaling.
Click the Terminate Button to stop all network activity.
A list of the active nodes in a network. It is only valid and/or populated
when this Terminal is "connected" to the network. The IP address listed in
this list is the IP address of the data port at that Terminal. The Handover
number, if present, indicates the order in which that node will take over
the network if the current network controller terminates.
Displays the IP address assigned to the data Ethernet port (J1).
This combo box enables the selection of a previously configured Satellite.
This is the Satellite beam that this terminal has been assigned to transmit
and receive in.
Pressing the Apply button updates the system with the new Satellite and
home beam.
9-3
Description
1000-7075 Rev E