MPM-1000A Operator Manual
10.2 R2CP Session Tab
The session display shows multiple rows. Each row represents a possible destination
for data flow from this NCW node. A destination can be a single node (Unicast), multiple
nodes (Multicast) or all nodes (broadcast).
Refer to Table 10-2 R2CP Sessions Tab for data descriptions for this window.
Control/Indicator/
Function
Update
R2CP Error
Multicast
Dest Rx Role
Id
L2 Subnets
Mean In Bit Rate
[kbps]
Mean Out Bit Rate
[kbps]
Mean Total Latency
[ms]
Current Data Rate
[kbps]
Figure 10-2 R2CP Sessions Tab
Table 10-2 R2CP Sessions Tab
This box indicates that the R2CP sessions have changed. To update the R2CP
session, see section 10.2.
This indicates an Error has been written to a trap File. See section 1.
See section 0.
Indicates whether the destination data flow is Unicast, multi-cast or broadcast.
Session identification number assigned by the router attached to the local node.
Reserved for future use.
A smoothed average of the bit rate sent from the router to this destination. In kilobits
per second.
A smoothed average of the bit rate that the local node has sent to the destination
over-the-air. In kilobits per second.
A smoothed average of the queuing time in the local node for this destination.
The current data rate this node is sending to the destination. Typically, this is the
same as the Mean Out Bit Rate. However, it is exaggerated by the Overload Factor,
and is set to 0 subject to the configurable Buffer Thresholds (in the configuration
section).
Description
10-4
1000-7075 Rev E