Human Computer Interface - L3 Communications MPM-1000A Operator's Manual

MPM-1000A Operator Manual
The CDU port (J2) of the Modem has a default IP address of 192.0.1.2.
The PC running the HCI must be on the same subnet (192.0.1.xxx)
when connected to the CDU port.
2) In Subnet mask, type in <255.255.255.0>.
3) You can leave the Default gateway field blank or it can be set to the default
IP address of the CDU Port (192.0.1.2).
192.0.1.1
Control/Data PC Control PC
f. Click OK to return to the Properties window.
g. Check the option for Show icon in notification area when connected.
h. Click OK to close out of the Properties window.
i. Exit out of the Network Connections window.
4.5

Human Computer Interface

The primary interface for Monitor and Control of the Modem is an HCI GUI running on a
PC that is attached via Ethernet to the Modem‟s CDU port. Modem operation is
organized into four (4) modes of operation:
MIL-STD-188-164A Waveform – In this mode the Modem is configured as an
SCPC Modem conforming to MIL-STD-188-165A. (See Section 10 for more
detailed operation)
NCW without SVOW – This is the most common mode of operation and places
the Modem in the NCW operation mode. To configure the Modem in this mode
terminal parameters are entered (See Section 6.1) and NM Parameters are
configured (See Section 9). If the Modem is designated as a NC then Network
Parameters are also configured. (See Section 8)
NCW with SVOW – In this mode of operation a 16 kbps SVOW data stream from
J3 is dedicated one of the available TX channels and one of the RX channels.
Maintenance – Maintenance mode is used for updating Modem Software.
NOTE
CDU
192.0.1.2
Figure 4-2 IP Scheme
4-3
Subnets
192.0.1.0/24
1000-7075 Rev E