Connector Removal; Figure 23: Pulling The Pull Tab; Figure 24: Removing The Connector Without Tools; Figure 25: Removing The Connector Using A Screwdriver - WAGO -I/O-SYSTEM 750 Series Manual
4fdi 24v profisafe v2 ipar safety 4-channel digital input module profisafe v2
Hide thumbs
Also See for WAGO-I/O-SYSTEM 750 Series:
Table of Contents
Advertisement
56
Mounting
Pos: 30.16 /Serie 753 (WAGO-I/O-SYSTEM)/Montieren/Lösen des Steckers von der Busklemme Serie 753 @ 4\mod_1240393485109_21.docx @ 31214 @ 3 @ 1
6.3.2
Connector Removal
1.
Remove the connector from the I/O module by pulling the orange pull tab
on the connector toward the top of the module.
Figure 23: Pulling the Pull Tab
The connector detaches from the module.
Figure 24: Removing the Connector Without Tools
2.
Alternatively, you can also use a standard screwdriver at the position shown
(in the figure below) to remove the connector.
Figure 25: Removing the Connector Using a Screwdriver
Pos: 31 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
753-661/000-003 4FDI 24V PROFIsafe V2 iPar
Version 1.4.0, valid from HW/SW Version 01/02
Manual
Advertisement
Chapters
Table of Contents
