B
External Connections
Warning:
suitable machinery and the supplied harness to lift the mass spectrometer.
Notice:
To avoid damaging the mass spectrometer, observe the following precautions:
•
Contact Waters Technical Service before moving it.
•
If you must transport the instrument, or remove it from service, contact Waters Technical
Service for recommended cleaning, flushing, and packaging procedures. See
B.1
External wiring and vacuum connections
Rear panel connections appear in the figure below. Note that the connectors and controls not
identified are for use by Waters engineers only.
Figure B–1:
Power
Turbo vacuum
To avoid skeletal or muscle injury associated with lifting heavy objects, use
Rear panel
Source vent
September 7, 2016, 715003560IVD Rev. C
Event inputs
and outputs
Shielded
Ethernet
Roughing pump
control
Source vacuum
Collision cell
gas inlet
(Argon)
Nitrogen inlet
Page 123
page
44.