Requirements And Limitations; Requirements; Limitations - Keysight Technologies FieldFox A Series User Manual

Table of Contents

ERTA (Extended Range Transmission Analysis) Mode - Option 209

Requirements and Limitations

— Two FieldFox units with option 209 installed. SA Mode is required for option

— Ethernet LAN cable(s). Either TWO cables that are used to connect both

When you change network connections, it may take up to 2 minutes for

the old address to be replaced by the new address. If the FieldFox was

initially assigned an IP address by a DHCP server, and then the FieldFox

LAN connection with a DHCP server is removed and is the FieldFox is

reconnected to a LAN segment with no DHCP server (such as a direct

connect to another FieldFox), the FieldFox may take up to two minutes to

self-assign an automatic private IP address. During this connection time

the last recognized DHCP address is displayed on the FieldFox, but is

— Two trigger cables that are long enough to connect the two FieldFox units,

— RF cabling to and from DUT.

— Power Splitter (Optional) for enhanced B/R ratio measurements.

The following SA features are removed in ERTA mode (Option 209):

— Channel Measurements, Tune and Listen, Interference Analysis, Radio

The following SA features are disabled during partnership synchronization:

— Video BW, SwpAcquisition, Frequency Count, Record/Playback, and certain

— The only keystrokes allowed on the Source unit are Send Text Message and

Keysight N9927-90001 User's Guide

units to the internet or ONE cable that is long enough to connect the two

FieldFox units. This may require a cross-over cable.

each with SMB (m) to SMA (f) connectors.

Standards, and Sweep Triggering.

Amplitude Units.

Table of Contents