Using The Antenna/Cable Editor - Keysight Technologies FieldFox A Series User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings
—
—
When finished, press Back to return to the previous menu.

Using the Antenna/Cable Editor

The Antenna Editor and the Cable Editor menus are very similar. Both tables
include header information, and a Frequency/Value table.
Figure 9-2 FieldFox Antenna Editor
How to use the Antenna/Cable Editor
— Press
— Then
— Then use the
158
Recall Antenna/Cable
specified Storage Device.
Storage Device Choose from: Internal, USB, SD. Learn more about these
selections in "Set File Type and Select Device" on page
New then Yes to clear all data from the existing Antenna or Cable
table and reset header information to default settings.
Edit Antenna or
arrows to select a field.
— To edit header information, press
using the FieldFox labeler.
——Description: Enter a description for the antenna or cable
correction table. This is NOT the filename used to save the file.
——Antenna Unit (Rcvr-side Antennas only): Units in which the
measurement will be displayed. Select NONE (default setting)
to select from standard SA Units on the Scale menu. Learn how
in "Scale and Units" on page
Read an existing Antenna/Cable file from the
Edit Cable to open the Antenna / Cable Editor.
Edit
153.
Keysight N9927-90001 User's Guide
677.
then modify the selected field