Keysight Technologies FieldFox A Series User Manual page 662

System Settings
System Configuration
— Press System 7.
— Then
— Then
— Then
— Then
— The Installer software opens after a couple of seconds.
If no files are displayed, verify that a USB memory or SD Card is installed
and press
— Then the
— Press
— "Current Step Progress:" bar and a "Total Progress:" bar are
— When the installation is completed, the FieldFox reboots.
How to backup files
This procedure backs up your user data to a USB or SD card. See also
restore files" on page
If you backup multiple versions of the user files, the FieldFox appends a
"_#" to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox.
From the initial Installer menu:
— Press
— Then
— A message is displayed: "Choose backup file location."
— Then choose either
— A progress bar and a message is displayed: "Saving user data..."
— Press
How to restore files
This procedure restores user files from a USB or SD card. See also
662
System Configuration.
More
Firmware Update
Start Installer
Refresh List.
arrows or the knob to scroll to the firmware you want to
install.
Start Install
displayed along with this message: "Copying package. Do not
remove install media."
662.
Utility
Backup Data
SD Card
Cancel to exit without backing up your files and returning to the initial
Installer menu.
or USB
Keysight N9927-90001 User's Guide
"How to
"How to backup