Pulse Measurement Settings; How To Select Pulse Measurement Mode; Measurement Selection; Frequency / Time - Keysight Technologies FieldFox A Series User Manual

Table of Contents

Advertisement

Pulse Measurements Mode – Option 330

Pulse Measurement Settings

Pulse Measurement Settings
Select Pulse Measurement Mode before making any setting in this section.

How to select Pulse Measurement Mode

— Press Mode
— Then
— Then

Measurement Selection

The pulse measurement results are presented as either a traditional power
meter display or as a trace graph.
How to select the Measurement
— Press Measure 1
— Then choose from the following:

Frequency / Time

How to set Frequency
— Press Freq/Dist
— Then choose from the following:
472
More
if your FieldFox contains more than five measurement modes.
Pulse Measurements
Average
Average power (Meter display)
Peak
Peak power (Meter display)
Pk to Avg
Displays the difference between the above two
measurements (Meter display)
Trace Graph
(default) The primary trace (Tr 1) plots pulse data in
amplitude versus time. Optionally, you can enable a secondary
'zoom' trace. Learn how in
— When a 'Meter display' measurement is selected, the following Pulse
Measurement Mode settings are identical to the standard USB Power
Meter Mode settings.
— Learn how to set Scale in
— Learn how to set Relative and Offset Power in
Power Measurements" on page
— Learn how to set Display Units in
— Learn how to set Limits in
"Zoom Window" on page
"Scale" on page
474.
"Relative and Offset
456.
"Display Units" on page
"Limits" on page
458.
Keysight N9927-90001 User's Guide
473.
456.

Advertisement

Table of Contents
loading

Table of Contents