Option 352 Outdoor Maps Setup Procedure - Keysight Technologies FieldFox A Series User Manual

On–the–Box Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option 233 on
N991xB), GPS (Option 307) and GPS Receiver (Option 307))
How to Set Up Mapping Settings

Option 352 Outdoor Maps Setup Procedure

Outdoor mapping requires GPS Option 307.
Saving and importing maps can be done now or after the outdoor map
locations have been measured. Before you can save and import maps via
the internet, your PC requires the FieldFoxMapping software. Refer to
"How to Install Node.js and Running the FieldFox Mapping Software" on
page
1. Set up your measurements in Channel Scanner, OTA, or Phased Array
2. Plan the area you want to map with GPS Option 307 enabled.
Saving and importing maps can be done now or after the outdoor map
locations have been measured. Refer to
Running the FieldFox Mapping Software" on page
Keysight N9927-90001 User's Guide
382.
Antenna. See also, Chapter 12, "Over–the–Air Measurements (OTA) – LTE
FDD Option 370 and 5GTF Option 377 (CPU2 Only),"
"Channel Scanner (Option 312)."
One or more are required:
— For setting up GPS Option 307, refer to
Settings," and then
— For setting up a phased array antenna, refer to
Rapid Prototype Phased Array Antenna – Option 360."
— For setting up a USB antenna, refer to
(Full Capability Requires EMF Option 358, and SA mode (Option 233
Mixed Analyzers))."
a. Optional (Can be done later): Save mapping pictures to the FieldFox
using USB storage device, SD card, or connect to LAN with internet
and download. Refer to
FieldFox Mapping Software" on page
http://na.support.keysight.com/fieldfox/help/Programming/webhel
p/FFProgrammingHelp.htm.
b. Optional (Can be done later): Overlay GPS located results onto
maps, Press Record Playback
> Interval Type Time Distance
> then Back, to exit the Record Playback menu.
c. Walk or drive around the area you want to map.
d. Optional: If you know your route, and have already downloaded a zip
file of your mapping location or are connected to the LAN, then
press System 7 >
then:
— Move the position cursor to current location:
Chapter 29, "System
"GNSS (GPS+) and GPS" on page
Chapter 14, "USB Antennas –
"How to Install Node.js and
"How to Install Node.js and Running the
382. For FTP, refer to
> Record Settings
(select one of these) >
Utilities > Mapping > Map Explorer (Get Maps)
and Chapter 26,
650.
Chapter 13, "5G
382.
> Meas Interval ON
Auto Save On
395