All About Trace Math; How To Display Data And Memory Traces; How To Perform Trace Math - Keysight Technologies FieldFox A Series User Manual

All about Trace Math

Trace Math is available in CAT (excluding DTF measurements), NA Mode, and FOPS (under USB
Power Meter mode).
Noise Figure (NF—Opt. 356) does not have trace math, but does have the
ability to display data and memory traces. Refer to
and memory
A trace is a series of measurement data points that are connected to form a line. This 'live' data
trace is updated as data points are measured.
A memory trace is a live trace that has been stored in the FieldFox volatile memory. It then becomes
static, meaning it is not updated with measurements. It can be displayed on the screen by itself, or
with a data trace for comparison purposes.
— In NA mode, memory traces are the same color as data).
— In CAT mode and FOPS, the data trace is displayed in yellow and the memory trace is displayed
in blue.

How to display data and memory traces

— Press Trace 6.
— Press Math and Memory
sounds to confirm the data trace has been saved to memory. There is no display annotation that
indicates that the memory trace has been stored.
— Press Data to view only the data trace.
— Press Memory
— Press Data & Memory

How to perform Trace Math

Trace math is performed between a live trace and a memory trace. When one of the following math
operations are selected, the yellow data trace displays the current measurement with the selected
trace math applied. The math operation symbol indicated below in [brackets] is displayed on the
lower left corner of the screen.
— Press Trace 6.
— If not already stored, press
— Then Data Math.
— Then choose one of the following:
— Data + Mem
— Data – Mem
618
Data Analysis Features

All about Trace Math

traces".
then Data->Mem
to view only the memory trace.
to view both the live trace and the stored memory trace.
Data->Mem to store the current live trace into memory.
[D+M] Current measurement data is added to the data in memory.
D-M] Current measurement data is subtracted from the data in memory.
to store the current live trace into memory. A 'beep'
Keysight N9927-90001 User's Guide
"How to display data