Keysight Technologies FieldFox A Series User Manual page 345

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
5. Entering the phased array antenna measurement type:
6. Using the table to enter phased array antenna settings, presetting the
Keysight N9927-90001 User's Guide
Refer to "Data Formats:" on page
Select Measure:
— Measure—choose:
— Bore-Sight
— Heat Map
— Polar ANT
— Park ANT
antenna, setting the antenna LAN IP, and clearing the graphics:
Refer to Figure 15 on page
Select Meas Setup:
— Antenna Settings—choose:
— Ball Antenna > LAN Address
— Settings–choose:
— Array Antenna–choose:
— Polar Display >Ref
— Sweep > Dwell Time (Optional. For pulsed RF
measurements it is recommended that the Dwell Time is
increased.)
— Sweep > Max Hold (Optional. For pulsed RF
measurements it is recommended that Max Hold is set to
OFF when using the Heat Map display. (Default = OFF).)
— Preset Antenna
— Ant LAN IP enter the Ball antenna's LAN IP. First three fields must
match the FieldFox's static IP address (default: 192.168.1.10). Refer
to Figure 14 on page
332.
or
or
or
351.
——Res BW or
——Video BW
——Beam Width
——Center
——Azimuth Ref
——Elevation Ref
presets the antenna settings factory defaults.
350.
345