Top Panel; Right Side Panel - Keysight Technologies FieldFox A Series User Manual

Preparing for Initial Use of Your New FieldFox
Take the FieldFox Tour

Top Panel

Caption Descriptions
Port 1 For CAT and NA measurements, use to make reflection measurements.
RF Output Maximum: ±50 VDC, +27 dBm RF
Also, for SA source output in SA mode.
Port 2 For SA, use to make all measurements.
SA RF Input
For CAT, NA, and VVM mode, use to make Port 2 transmission
measurements.
Maximum: ±50 VDC, +27 dBm RF.
GPS Ant SMA (f) connector for use with built-in GPS. Produces a 3.3 VDC bias
voltage for the antenna pre-amplifier. Use with a GPS antenna such as
N9910X-825. Other GPS antennas can also be used.
Ref In SMA (f) connector for use with Frequency Reference Source and External
Trig In Trigger Input signal.
Maximum: 5.5 VDC.

Right Side Panel

Connector Description
Ethernet cable connector to read trace data using the FieldFox Data Link
Software and connect to the FieldFox remotely.
Download the latest version of the software at:
www.keysight.com/find/fieldfoxsupport
38
Learn More:
"CAT Mode Settings"
on page 47
"NA Mode Settings" on
page 87
Chapter 9, "SA
(Spectrum Analyzer)
Mode", on page 145
"SA Mode Settings" on
page 148
"GNSS (GPS+) and
GPS" on page 650
"Frequency Reference
Source" on page
"Triggering" on
page 172
Learn More:
"LAN Settings" on
page 659
Keysight N9927-90001 User's Guide
654.