Keysight Technologies FieldFox A Series User Manual page 129

Calibration for NA, CAT, and VVM Modes
4. Calibration Type - The FieldFox always RECOMMENDS a Cal Type that will
Begin Calibration
— Press Start Calibration.
If an error appears ("Failure to compute calibration steps..."), check to
ensure that the frequency range of the Cal Kit covers the frequency range
of the measurement. You can verify the frequency range of your Cal Kit at:
www.keysight.com/find/fieldfoxsupport. Click Cal Kits.
— Follow the Cal Wizard prompts. Connect the specified standard at the point
— At any time, press Back to re-measure a standard if you feel it was not
— Press
CAL ON U
corrected with the Mechanical Cal.
Keysight N9927-90001 User's Guide
— Press Change Gender
connector.
— Then press
the process.
— For each port:
— Use the
that you have, and are going to use, for the specified ports.
— Press Next...
process.
— Then press
quickly and accurately calibrate all of the displayed S-parameters.
Change from the RECOMMENDED Cal Type ONLY if you understand the
implications. Learn more about Cal Types in
page 134.
To select a different Cal Type:
— Press Change Cal
— Then using the
— Then press Select and
where the DUT will be connected, then press Measure.
properly connected.
Finish to complete the calibration.
is shown on the screen for all displayed measurements that are
to change the gender of the DUT
Next... to confirm the selection and continue
arrows or rotary knob to select the Cal Kit
to confirm the selection and continue the
Finish to end the selection process.
"Calibration Type" on
Type.
arrows or rotary knob, select a Cal Type,
Finish.
129