Keysight Technologies FieldFox A Series User Manual page 545

Channel Scanner (Option 312)
How to Set Up Channel Scanner
— Optionally choose from the following:
When the table edits are complete
— Press
— Press
— Press
—
About Antenna and Cable files
— Cable files are saved and recalled from the Cables folder.
— Antenna files are saved and recalled from the Antenna folder.
— To DELETE Cable or Antenna files, use the Manage Files feature. Learn more
— If the folder does not already exist on a USB or SD card, it is created
Keysight N9927-90001 User's Guide
——For both Cable and Antenna correction, Positive numbers
indicate loss (we need ADD something positive to compensate
for it), and Negative is indicative of some existing gain.
——Antenna Factor describes the dB value needed to accurately
display a far-field signal in terms that are in the units listed
below. When the antenna has low gain, or low efficiency, the
dB value to be added is larger.
—When one Freq/Value pair is entered, that correction value is applied
to the entire displayed frequency span.
—When two or more Freq/Value pairs are entered, the data points
between the lowest and highest frequencies are corrected. Linear
interpolation is applied between frequencies when necessary.
—Previous / Next Page
data.
— Add Row Add a blank Freq/Value pair to the table,
—Delete/Clear then:
——Delete Row
table.
——Clear All
and resets header information to default settings.
Done to close the Antenna/Cable Editor.
Save Antenna or
Storage Device. Enter a filename using the FieldFox labeler (learn more in
"How to use the FieldFox labeler " on page
Antenna and Cable files below.
Recall Antenna
the specified Storage Device.
Storage Device Changes the device used to save or recall files. Choose
from Internal (default setting), USB (must be connected) or SD card. This is
a different setting from the Save/Recall Storage Device setting.
in "Manage Files" on page
automatically before storing the file.
Quickly scrolls through pages of Freq/Value
Remove the selected Freq/Value pair from the
then Yes Remove all Freq/Value pairs from the table
Save Cable to save your changes to the specified
674). Learn more about
or Recall Cable to load an Antenna or Cable file from
680.
545