Channel Selection - Keysight Technologies FieldFox A Series User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings
— Then
— Then
— Then
— Then select the *.csv file using the
— Custom Radio Standards can be removed from the FieldFox by selecting
— Then select the *.csv file to delete using the
To overwrite a custom standard that is already uploaded to the FieldFox,
you must first delete the *.csv file from the FieldFox, then re-upload the file
that contains the standard. A predefined internal standard (such as GSM
450) can NOT be deleted from the FieldFox.

Channel Selection

After a Radio Standard has been selected, the frequency range can be
changed by selecting channel numbers rather than frequency. Once enabled,
the channel number is appended to the X-axis frequency range.
How to Enable Channel selection
— Press Freq/Dist
— Then
— Then
With Unit = Chan,
Channel
How to change the Channel Number of the Measurement
With Unit =
of the selected Radio Standard.
— Press Freq/Dist
— Then choose from the following:
Keysight N9927-90001 User's Guide
Radio Standard
Radio Standard
Import Radio Standards
Enter.
Measure 1 then Radio Standard
press Enter.
More
Unit Freq Chan
Channel Direction
Step.
Chan the FieldFox will NOT allow you to specify channels outside
—Center Channel Places the center frequency of the specified channel
in the middle of the X-axis.
—Start Channel Places the lowest frequency of the specified channel at
the beginning of the X-axis.
—Stop Channel Places the highest frequency of the specified channel at
the end of the X-axis.
arrows or rotary knob and press
then Delete Radio Standard.
arrows or rotary knob and
becomes available and CF Step alters to
151