Source Tracking Offset And Offset Reversal - Keysight Technologies FieldFox A Series User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings
— Antenna files are saved and recalled from the Antenna folder.
— To DELETE Cable or Antenna files, use the Manage Files feature. Learn more
— If the folder does not already exist on a USB or SD card, it is created
— All SA mode Antenna and Cable files are saved and recalled as *.csv files,
— The FieldFox can also read *.ANT (Antenna) files that were created from
— SA Mode cable or antenna (*.csv or *.ANT) files can NOT be edited in Data
How to create a Cable file from an S21 (NA mode) or an Insertion Loss
(CAT mode) measurement
1. Measure the S21 or Insertion Loss of a cable. In NA mode, select either
2. Use Manage Folders to change the active folder to CABLES. Learn how in
3. While in NA mode, save the measurement as a *.csv file. Learn how in
4. In SA mode, select Corrections, then recall the *.csv file for correction.

Source Tracking Offset and Offset Reversal

This feature requires:
— N991xA and N995xA FieldFox Combination Analyzers to have Options 209,
— N993xA and N996xA Spectrum Analyzers to have Options 209 and 220
Source offset tracking is used to offset the Source frequency from the Receiver
frequency by a fixed offset at every tune frequency. This feature is used when
the DUT contains a frequency translation device or mixer.
How to set Tracking Offset and Offset Reversal
— On the Receiver unit, press Meas 1
— Then
— Then
— Then choose one or both of the following:
160
in "Manage Files" on page
automatically before storing the file.
which allows them to also be read by spreadsheet programs.
older Keysight Spectrum Analyzers.
Link software.
LogMag, Linear, or VSWR formats.
"Manage Files" on page
to Save a File" on page
210, and 233
Source
Advanced
—Tracking Offset Enter an offset value.
680.
680.
672.
Keysight N9927-90001 User's Guide
"How