Frequency Range; Scale Settings - Keysight Technologies FieldFox A Series User Manual

CAT (Cable and Antenna Test) Mode
CAT Mode Settings
— When finished changing ALL settings, press

Frequency Range

Set the range of frequencies over which you would like to make CAT Mode
measurements
When the frequency range is changed after a calibration is performed, the cal
becomes interpolated. Learn more in
How to set Frequency Range
— Press Freq/Dist.
— Then choose from the following
— Follow each setting by entering a value using the numeric keypad,

Scale Settings

Adjust the Y-axis scale to see the relevant portions of the data trace. The Y-axis
is divided into 10 graticules.
This setting can be changed at any time without affecting calibration accuracy.
How to set Scale
— Press Scale / Amptd.
— Then choose from the following three methods:
Keysight N9927-90001 User's Guide
— Left The Settings table is shown to the left of the trace window
— Bottom The Settings table is shown below the trace window
— Start and Stop frequencies - beginning and end of the sweep.
— Center and Span
frequencies (half on either side of center).
arrows, or the rotary knob.
— After using the keypad, select a multiplier key. Learn about multiplier
abbreviations in
— After using the
amount of frequency increment is based on the current span and can
NOT be changed in CAT Mode.
1. Autoscale Automatically adjusts the Y-axis to comfortably fit the
Minimum and Maximum amplitude of the trace on the screen.
2. Set Scale, acquisition, and Reference Position:
— Scale
areas of the trace
"Interpolation *" on page
frequencies – the center frequency and span of
Chapter 1, "Overview."
arrows or the rotary knob, press Enter. The
Manually enter a scale per division to view specific
Done to save your settings
140.
49