Alignments; Trace Display States (Iqa Mode); How To Display The Trace States - Keysight Technologies FieldFox A Series User Manual

IQ Analyzer (IQA) – Option 351 (CPU2 Only)

Alignments

Alignments

The IQA mode requires all three alignment types: amplitude, RF burst, and
channel equalization. Refer to the SA chapter's
information on all alignments.

Trace Display States (IQA Mode)

If you have Option 351 I/Q Analyzer option, you can directly save your data as
MATLAB files (*.mat). Refer to
(CPU2 Only)", on page 257
If you have the FieldFox's Remote Server mode (89600 VSA software
connectivity), you can use the VSA software to capture and record your
data as MATLAB files (*.mat). Learn more about FieldFox and 89600 VSA
software, refer to
SA Hardware/SA Option 233)"
http://rfmw.em.keysight.com/wireless/helpfiles/89600B/WebHelp/89600
.htm.
In IQA Mode you can display up to four of the following types of trace states.
All IQA settings are applied to all displayed traces. See also
and SA Mode)" on page
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View

How to display the Trace States

— Press Trace 6.
— Then
— Then
— Then choose from the following Trace States:
Keysight N9927-90001 User's Guide
Chapter 16, "Remote Server Mode (Requires CPU2 and
602.
Trace 1,2,3,4 repeatedly to select a trace number to display or change
its state. Traces are displayed in the following colors:
— Trace 1 – Yellow
— Trace 3 – Orange
State [current setting]
—Clr /Wr (Clear/Write) Displays the actual measured data for each
acquisition.
—MaxHold Displays the maximum response of the input signal at each
data point over multiple acquisitions. See also Average Count in
"Adjusting the Measurement Setup Settings" on page
"Alignments" on page 180
Chapter 11, "IQ Analyzer (IQA) – Option 351
and to Chapter 31, "File Management."
and to
Trace 2 – Blue
Trace 4 – Green
for
"Marker Trace (IQA
270.
281