Emf Setup Procedure - Keysight Technologies FieldFox A Series User Manual

Table of Contents

Advertisement

SA (Spectrum Analyzer) Mode
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))

EMF Setup Procedure

When the USB antenna correction factors are imported, EMF (Option 358)
couples many settings to ease setting up the EMF measurement (e.g.,
Apply Corrections is enabled, all X, Y, and Z antenna axes are enabled, and
Amp Corr Select is set to TriAxial XYZ).
1. Setup the FieldFox Spectrum Analyzer for a Channel Power measurement.
If necessary, this step can be skipped and done after the USB antenna is
set up.
2. Connect a USB antenna's RF cable to the SA RF Input, port 2 and the USB
Only Agos Advanced Technologies SDIA–6000 Triaxial Isotropic USB
antenna is currently compatible with EMF (Option 358).
3. Importing and selecting the X/Y/Z antenna factors:
If the antenna factor import is successful, the FieldFox displays:
"Success: Antenna Factors Imported: Tri-Ax Antenna ID:
->[R] Antenna ID: SDIA-6000-1006 ->[]". The last 4-digits will vary
for each antenna (i.e., "1006" value will vary).
If the FieldFox displays this error Error: USB antenna Error: Not
found or Unable to communicate with antenna. Ensure it is
connected. is displayed, verify the USB antenna is connected correctly.
See also,
Keysight N9927-90001 User's Guide
a. Press Mode >
SA
Press Measure 1 >
Channel Measurements
See also,
"Channel Measurements" on page
connector to a FieldFox USB port. See also,
to
Chapter 14, "USB Antennas – (Full Capability Requires EMF Option 358,
and SA mode (Option 233 Mixed Analyzers))."
a. Press System > Utilities>
— Then
Import Antenna
antenna's memory over the USB connection (this may take 5
seconds or so and vary with the Triaxial antenna).
"Troubleshooting" on page
— Then
USB Antenna [Tri Axial]
— Optional: Press
for default operation. When AUTO is selected the application (e.g.,
Channel Power or OTA) controls the axes and switches as needed.
With the AUTO setting, all antenna elements (X, Y, and Z) are OFF.
>
USB Antennas
– to import the antenna factors from the
376.
verify Triaxial (default) is selected.
Antenna Axis
the antenna axis should be set to Auto
>
Channel Power
195.
Figure 9-13 on page 208
and
209

Advertisement

Table of Contents
loading

Table of Contents