Keysight Technologies FieldFox A Series User Manual page 210

SA (Spectrum Analyzer) Mode
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
4. Modifying the EMF settings:
5. Enabling the imported USB antenna factors and Cable factors:
Figure 9-14 SysCtrl Triaxial [N] Softkey – With the X–Axis Dipole Selected
210
— Press Back > Back
Press Meas Setup 4
— Then More > EMF
— EMF Meas OFF ON
— EMF Units
— Back
For more details on editing the USB antenna, refer to
Antennas – (Full Capability Requires EMF Option 358, and SA mode
(Option 233 Mixed Analyzers))."
a. Enabling the Channel Power: Press Measure 1 >
Measurements
b. To enable the Triaxial antenna for EMF: Press Meas Setup 4 >
Triaxial [OFF] >
With Sum all, the field strength from all three axes is summed and
displayed. The RF measurements are switched between the three
different antennas (three dipoles), and the resulting summation of
the total power collected, and averaged.
Alternatively, you can select either of three axes to individually
measure the field strength in the one direction.
c. Else, if the SysCtrl Triaxial
[OFF] is not viewable). The SysCtrl Triaxial softkey is not editable,
and indicates the System control softkeys are manually controlling
a single X, Y, or Z antenna dipole for uncorrected use. [X, Y, or Z] is
displayed to indicate which one of the X/Y/Z dipole axes is enabled.
If for example the X axis has been selected in the System > Utilities
> USB Antenna menu, then USB Antenna [X] is displayed to
indicate the X axis measurement (i.e., this uncorrected manual
mode is typically used when no EMF Option 358 is installed). Refer
to Figure 9-14.
d. Modifying the Amplitude Correction Selection:
Press Scale/Amptd >
— Amp Corr Select [Triaxial XYZ]
following:
to exit the USB Antenna softkey menu.
then
disable/enable the EMF measurement.
choose dBuV/m (default) or V/m.
to exit to the previous softkey menu.
> Channel Power
Sum All
softkey is viewable (i.e.,
See also step f.
More > Corrections
Keysight N9927-90001 User's Guide
Chapter 14, "USB
Channel
EMF TriAxial
> More then
- then choose one of the
EMF