Data Logging Procedure; To Change Recording Configuration Settings - Keysight Technologies FieldFox A Series User Manual

Over–the–Air Measurements (OTA) – LTE FDD Option 370 and 5GTF Option 377 (CPU2
Only)
How to Use Data Logging (OTA Options 370 and 377)
When GPS is enabled,
display. Learn more in
If Recording or Playback is not occurring when you think it should, check
the following:
— Is the sweep in HOLD? (upper-left annotation), or check the Sweep
— Is Recording or Playback Paused? (mid-left annotation)
— Is the Record or Playback Interval set too long? (Configuration

Data Logging Procedure

Record-Play files are saved to:
— Record-Play files are save-recalled to:
— Press Trace 6
— Then
— Then
— Then
During recording, choose from the following:
—
—
—
—

To change Recording Configuration settings:

— Press Measure 1
— Then
Keysight N9927-90001 User's Guide
GPS R
"GNSS (GPS+) and GPS" on page
menu for Continuous set to OFF.
settings.)
"[CurrentDevice]\RecordPlayback\OTA"
More
Data Logging
Record
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. For more, refer to
FieldFox labeler " on page
File Save to opens a softkey menu to enable you to save your data log and
related file settings. For more, refer to
settings:" on page 323.
Record Settings to opens a softkey menu to enable you change your record
related settings. For more, refer to
settings:" on page 323.
More > Data Logging
is indicated at the bottom of the FieldFox
674.
"To change Recording Configuration
"To change Recording Configuration
> Record Settings
650.
"How to use the
323