Keysight Technologies FieldFox A Series User Manual page 298

Over–the–Air Measurements (OTA) – LTE FDD Option 370 and 5GTF Option 377 (CPU2
Only)
How to Set Up Over–the–Air (OTA) Mode Settings
If after making the setting changes in this section, no data is displayed,
refer to
Display does not update (refresh), until all active component carriers (CCs)
have been scanned.
13. Enable the
Spectrum and Strip Chart information is not recorded. Only the Table and
Bar Chart data are saved. See
Record-Play files are saved to:
Learn more about file settings, refer to
298
than 900 Hz, no data is displayed. 5GTF: Default = 1%, i.e., if a
carrier signal's sync correlation is smaller than 1%, no data is
displayed).
"Troubleshooting" on page
Record Playback
— Press Measure 1
— To set Record Playback—choose:
— Record or
— Playback
——Play or
——Recall Logs
Record-Play files are save-recalled to:
——
"[CurrentDevice]\RecordPlayback\OTA"
— Settings
——To set
326.
settings:
(If you have previously stored data recordings.)
"Data Logging Procedure" on page
File Settings choose:
Chapter 31, "File Management."
——File Name enter a filename
——Device choose where to store your data
files
——File Type > CSV
type (Default: KML)
or
——File Overwrite OFF ON
——Then Back
Keysight N9927-90001 User's Guide
323.
or KML choose a file