How To Select Spectrum Emission Mask (Sem) Measurement - Keysight Technologies FieldFox A Series User Manual

SA (Spectrum Analyzer) Mode
Spectrum Emission Mask (SEM) — (SA Mode Only)
Figure 9-18 SEM Example FAIL Data - Absolute Limit (Blue), Relative Limit (Violet), Trace
(Yellow), and Tabular Data

How to select Spectrum Emission Mask (SEM) Measurement

— Press Measure 1
— Then
— Then
When SEM is selected, the following settings are maintained from a previous
measurement: Center Frequency, Preamp ON|OFF, and RF Attenuation.
Setting up the FieldFox for Spectrum Emission Mask (SEM) Measurement
1. Press Measure 1 >
2. Press Meas Setup 4 then optionally select:
220
Channel Measurements
Spectrum Emission Mask
Channel Measurements
— Averaging Enable/disables averaging and sets the number of trace
averages (Default is OFF).
— Meas Type Then select one of the following:
> Spectrum Emission Mask
Keysight N9927-90001 User's Guide