Table of Contents
Advertisement
Hardware and Software Requirements
Before you start installing the W3301A interposer, ensure that you have the following list of hardware
and software components needed for this interposer.
Hard ware Requirements
U4164A or U4154A/B AXIe-based Logic Analyzer Module
M9502A 2-slot or M9505A 5-slot AXIe chassis to install the logic analyzer module
M9536A embedded controller or host PC with PCI express adapter card for the chassis
W3301A LPDDR3 Interposer(s)
E5406A/B probes (with retention modules) to connect the interposer to the logic analyzer cables
Two probes needed for each interposer. The probes are sold separately from the interposer.
U4201A Logic Analyzer cables to connect the E5406A/B probes to the Logic Analyzer module
Two cables needed for each E5406A/B probe.
Software Requirements
Logic and Protocol Analyzer software version 6.30 or
higher.
(Required)
B4661A Memory Analysis Software Tools Package
version 6.30.1008 or higher. (Required)
The below-mentioned licensed/unlicensed software features from the B4661A software package are required for W3301A.
Default LPDDR configuration files
(Required)
DDR Setup Assistant and DDR Eyefinder software
(Required)
DDR Custom Configuration Creator Tool
(Required)
B4661A-2FP LPDDR Bus Decoder software
(Recommended)
B4661A-3FP DDR 2/3/4 Protocol Compliance and
Analysis toolset
(Recommended)
B4661A-4FP DDR 2/3/4 Memory Analysis Viewer
(Recommended)
Keysight W3301A LPDDR3 BGA Interposers Installation Guide
Licensing
Unlicensed base software with
additional licensing options
Includes unlicensed as well as
licensed features
Available as an unlicensed standard
feature with the B4661A package.
Available as an unlicensed standard
feature with the B4661A package.
Available as an unlicensed standard
feature with the B4661A package.
Available as a licensed feature with
the B4661A package
Available as a licensed feature with
the B4661A package
Available as a licensed feature with
the B4661A package
Description
Base software platform for configuring and using Keysight's logic
analyzer modules.
Base software package that includes configuration files and tools
to help you perform DDR/LPDDR post-process as well as
real-time protocol compliance violation testing, decode and view
memory transactions, and set up your logic analyzer for
DDR/LPDDR data capture and analysis.
Includes default XML configuration files for use with the W3301A
interposer.
A wizard- like application to help you set up your U4164A logic
analyzer properly for use with the W3300A interposers.
Allows you to define the footprint layout as per your custom
probing solution used in the DDR/LPDDR setup and then create
an XML configuration file based on this footprint information.
Allows you to decode and view transactions, commands, and
data from a LPDDR1, LPDDR2, LPDDR3 or LPDDR4 SDRAM
memory bus in your device under test.
A set of tools to:
•
evaluate and analyze the captured LPDDR data.
•
perform real-time or post process compliance.
•
set up a trigger on the specified address.
•
graphically profile the distribution of memory accesses.
A viewer installed and displayed within the Logic and Protocol
Analyzer GUI to analyze:
•
memory traffic statistics.
•
refresh rate and self-refresh periods.
•
distribution of memory accesses.
•
memory performance measurements.
Introduction
1
13
Advertisement
Table of Contents
