To Change Recording Configuration Settings; How To Playback - Keysight Technologies FieldFox A Series User Manual

On–the–Box Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option 233 on
N991xB), GPS (Option 307) and GPS Receiver (Option 307))
How to Record/Playback (Option 352)
— Then
During recording, choose from the following:
—
—

To change Recording Configuration settings:

— Press Trace 6
— Then
— Then
— Then
Learn more, refer to the

How to Playback

— Press Trace 6
— If the session is already open, skip the following step. Otherwise:
Keysight N9927-90001 User's Guide
Record
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. Then choose from the following:
— Then Save Recall Rec-Playback
change your file settings. Learn more, refer to
Configuration settings:" on page
——Press Save Log File
save device is Internal).
— Then Record Settings
settings. Learn more, refer to
settings:" on page
Data Logging then choose:
Record Settings
— Optional: Then Meas Interval
——Then Interval Type
——Then, if applicable
Or
——Then, if applicable
miters.
Save Recall Rec-Playback
— Then Device (Internal (default), SD Card, or USB)
— Then File Type (CSV, DREC, or KML (default))
Chapter 31, "File
To save a log file, recall logs, or
407.
to save the current Table data (i.e., default
To change your measurement interval
"To change Recording Configuration
407.
> ON
> choose Time or Distance.
Time Interval enter time interval in seconds.
Distance Interval
Management".
"To change Recording
enter distance interval in
407